Begin Assembly
NOTE
DO NOT fully tighten the fasteners until instructed to do so.
Remove shoulder pad pivot supports
Disconnect the pre-assembled shoulder pad assemblies (Figure 1).
Assemble the frame
1.
Place the base frame on the floor where you plan to use the equipment.
2.
Attach the rear upright to the base frame using four bolts and washers
(Figure 2).
Figure 2
3.
Attach the center frame to the base frame using two bolts and washers
and to the rear upright using two bolts and washers .
4.
Fully tighten all bolts.
5.
In the center frame bracket, position the shoulder frame support pivot to
align the bracket and frame openings. Slide the short axle through the base
of the shoulder frame support and attach the shoulder frame support using
two bolts and two end caps (Figure 3).
NOTE
The axle should slide easily through the openings. If it does not, use a
rubber mallet to gently tap it through the opening.
Figure 3
Figure 1
3
