EFX 885, 835, 825
Service Manual 20039-166
Page 116
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Note:
Do not use an electric screw driver or over tighten the screws. Over tightening may damage
the console. This type of damage is not covered under warranty.
18.
Place the P20 console on the maintenance access hook.
19.
Reconnect the Data cable, Auto Stop cable (Treadmill only), Stop Key cable (Treadmill only), Hand Held HR
cable, Wireless HR cable, and the Earth Ground wire and to the Upper PCA.
See Diagram 6.6.5.
20.
Replace the access cover with the hardware removed in step 6.
21.
Tilt the console back against the mounting plated. While tilting the console back feed the excess cable into
weldment tube making sure that the cables will not become pinched.
22.
Fasten the console to the dash mounting plate with the four screws removed in step 4.
See Diagram 6.6.2.
23.
Fasten the dash transition cover using the two screws removed in step 3.
See Diagram 6.6.1
24.
Check operation per Section Seven.
Summary of Contents for EFX 825
Page 15: ......
