EFX 885, 835, 825
Service Manual 20039-166
Page 141
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 10.2 Replacing the Lift Covers
1.
The large upper section of the front cover is fastened to the lower cover sections. However, there are two
plastic clips, one on each side of the upper lift cover, that retain the upper portion of the lift cover to the
uprights. To remove the upper lift cover section, lower the incline to its lowest position, to provide
clearance.
2.
The plastic cover clips must be carefully levered out of their mountings. Insert a narrow flat bladed screw
driver in the slot in the front of the cover clip. See Diagram 10.2.1.
Diagram 10.2.1 - Lift Cover Clip
3.
Carefully pry the cover clip away from the pivot cover. There are latching tabs in the front and rear of the
cover clip. All of the latching tabs must disengage from the pivot cover in order to remove the cover clip.
4.
Lift the upper lift cover section off of the lower cover sections.
5.
Set the replacement upper lift cover section on in its mounting position on the lower cover sections.
6.
Replace the cover clips by setting them in their mounting position and pressing them into place. Press the
rear portion of the clip into place first then the front portion of the cover clip.
Replacing the Lower Front Lift Cover Section
7.
Remove the upper lift cover section as described above.
8.
Remove the four screws that fasten the front cover section to the rear cover section. Remove the front
cover section from the EFX.
9.
Set the replacement front cover section in its mounting position and fasten it with the four screws removed
in step 4.
Cover Clip
Slot
Lift Cover
Pivot Cover
Summary of Contents for EFX 825
Page 15: ......
