EFX 885, 835, 825
Service Manual 20039-166
Page 158
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
4.
Slide the stairarm onto the crankarm and set the stairarm in its ramp track. Fasten the stairarm to the
crankarm with the retaining ring removed in step 7.
5.
Slide the large black spacer onto its mounting position on the replacement stairarm. Slide the steel spacer
into the end of the stairarm connector. Fasten the stairarm connector to the stairarm with the bolt,
removed in step 6, and a washer on each side of the steel spacer in the end of the stairarm connector.
6.
Align the T-nuts on the ramp trim(s) with the channel in the bottom front of the ramp. Slide the trim onto
the ramp while feeding each T-nut into the ramp channel. Do not tighten the trim fastening screws at this
time. Repeat this procedure with the remaining trim strip, if required.
7.
Set the ramp end cap at its mounting position and fasten it with the screws removed in step 3.
8.
Align the ramp trim(s) with the ramp end cap and tighten the five trim mounting screws.
9.
Set the ramp center cover at its mounting position and press downward to snap it onto place.
10.
Replace the lift cover per Procedure 10.2.
11.
Replace the stairarm cover(s) with the hardware removed in step 2.
12.
Replace the left and right side covers per Procedure 10.1.
Summary of Contents for EFX 825
Page 15: ......
