EFX 885, 835, 825
Service Manual 20039-166
Page 165
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 10.18 Replacing a Battery
1.
Remove the lift cover per Procedure 10.2.
2.
Remove the four screws that retain the lower front cover section, remove the lower front cover section and
set it aside.
3.
Remove the hitch pin from the clevis at the lower mount of the incline motor. Remove the clevis pin from
the lower incline motor mount. Lift the incline motor out of its mounting position and set it on the floor in
front of the EFX. Refer to Diagram 10.18.2.
Diagram 10.18.2 - Replacing a Battery
4.
Remove the two screws that fasten the battery bracket to the rear cover section and remove the battery
bracket.
5.
Slide the battery out of the rear cover section and set it on the floor beside the incline motor.
6.
Disconnect the red and black wires from the battery.
7.
Connect the red and black wires disconnected in step 6 to the replacement battery. The red wire must be
connected to the terminal marked with the red dot.
8.
Set the battery in its mounting position. Set the battery bracket in its mounting position and fasten it with
the screws removed in step 8.
9.
Fasten the clevis pin with the hitch pin.
10.
Set the lower front cover section in its mounting position and fasten it with the four screws removed in step
2.
11.
Replace the lift cover per Procedure 10.2.
Rear Cover
Section
Incline
Motor
Battery
Red Dot
Red Wire
Summary of Contents for EFX 825
Page 15: ......
