Procedure 7.23 - Replacing a Ramp Mounting Bracket
Warning:
Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm, when the
rear covers are removed.
Procedure
1.
Raise the incline to its maximum position.
2.
Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
3.
Place a support (such as a piece of wood) between the rear of the ramp and the frame. the
support must fit snugly so that it will support the ramp when the ramp mounting bracket is
removed. The support will also facilitate the mounting and alignment of the replacement
ramp mounting bracket.
4.
Remove the four screws that fasten the ramp mounting bracket to the ramp.
Diagram 7.21 - Ramp Mounting Bracket
5.
Remove the two large pivot bolts that fasten the ramp mounting bracket to the frame.
6.
Set the ramp mounting bracket at it mounting position and fasten it to the frame with the
hardware removed in step 5. Torque the bolts to 480 inch pounds (40 foot pounds).
7.
Fasten the ramp mounting bracket to the ramp with the hardware removed in step 4, torque
the screws to 144 inch pounds (12 foot pounds).
8.
Remove the support from the rear of the ramp.
9.
Thoroughly, test the EFX per Section Four.
Ramp
Ramp Bracket
Mounting Bolts
Pivot Bolt
Summary of Contents for EFX EFX 5.23
Page 79: ...Block Diagram 8 2 5 23 5 25...
