EFX5.25 Elliptical Fitness CrossTrainer Assembly Guide
7
Before exercising, make sure the EFX is level and does not wobble
from side to side.
Important:
If the EFX is placed on a slightly uneven surface, turning
the leveling pads can help, but will not compensate for extremely
uneven surfaces.
1. Kneel by the side of the stabilizer and lift the base slightly so you
can access the levelers.
2. Rotate the levelers as needed.
3. When the EFX is level, fully tighten the lock nut and lower the EFX
to the floor.
Connect the power cord.
CAUTION: Use the supplied power cord. Do not remove or otherwise
bypass the 3-prong plug with an adapter in order to use a non-
grounded outlet. Do not plug the EFX into a power transformer in
an attempt to adjust the voltage requirements. Failure to follow
these instructions might damage the unit and will void the Precor
Limited Warranty. If an appropriate cord for your location was not
included with your EFX, please contact your Precor dealer for the
proper Precor power cord. For more information on authorized
Precor dealers in your area, please contact Customer Support at
www.Precor.com.
1. Insert the power plug connector into its receptacle at the rear of
the unit.
2. Plug the other end into a grounded outlet so you can maintain a
consistent power source without overloading any other circuitry.
Be sure to use the appropriate voltage. Refer to
Grounding
Instructions
in the owner’s manual.
Turn the unit On.
Use the power switch to turn the unit On. Check that the Precor
banner appears on the display. If the display remains blank, cycle the
power. If the display continues to remain blank, check the cable
connections.
Important:
Make sure the locking pin is removed and stored before
you begin exercising.
Summary of Contents for Elliptical Fitness Crosstrainer EFX 5.25
