There are latches on the plastic covers that must be engaged to ensure a good
fit. Review the follow procedure before starting the cover assembly.
To attach the side covers:
1. Position one of the side covers against the console frame with its ramp latch
setting on top of the ramp and its wing edge fitted into the arm as shown
below.
Important
Flex the plastic to fit it against the frame. DO NOT pinch or crush
the cable during assembly.
Figure 11
2. Position the second side cover against the console frame.
3. Identify where the covers join on the bottom and press upward to snap the
internal latch together.
Figure 12
4. Press the top of the covers together to engage the top internal latch.
Figure 13
5. Snap a pivot bracket onto the boss of each side cover and then attach each
bracket using two screws
.
Note
The bracket should fit tightly against the assembly.
Figure 14
9
Summary of Contents for Elliptical Fitness Crosstrainer Experience 700 Series
Page 2: ......
Page 3: ...Table of Languages English 1 3...
Page 11: ...11...
Page 12: ...EFX 700 Line Assembly Guide P N 304382 101 rev B ENU 2017 Precor Incorporated January 2017...
