7. Remove the hitch pin from the Lift Motor clevis pin. Then, while holding the lift motor
assembly, slide the clevis pin to the left just enough to clear the bracket right side bolt
hole. Then tilt the lift motor assembly forward enough for the jackscrew to clear the
inside of the frame tower weldment and then lift to remove. Do not fully remove the
clevis pin to remove the Lift Motor Assembly. Retain part(s) and/or fastener(s) for install-
ation.
8. Unscrew the Yoke Assembly from the jackscrew and remove. Retain the Yoke
Assembly for installation
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 127
6 Replacement Procedures
Lift Motor Replacement