.
Installation Instructions
1. If this is a used lift motor replacement, clean and apply a thin layer of synthetic lubricant
to the jackscrew.
Lubricate the lift motor jackscrew
2. Lay the replacement Lift Motor on the floor in front of the elliptical and connect the input
power/control cable.
3. .If the lift motor is working, access the
CROSSRAMP TEST
diagnostic test and raise
the crossramp incline to level 10.
a. .On LED (P10, P30, P30i and P31) consoles: Access diagnostic test menu
(51765761) and select
MACHINE TEST
>
CROSSRAMP TEST
.
b. .On touchscreen (P62, P80, and P82) consoles: Access the Service menu
(51765761) and select
System Settings > Systems Test
>
CrossRamp Test
.
4. Disconnect the input power/control cable.
5. Install and calibrate the lift motor.
a. While installing and/or adjusting the Yoke assembly on the jackscrew, do not
allow the jackscrew to rotate invalidating the lift motor level 10 jackscrew cal-
ibration position. If the jackscrew does rotate, reconnect the lift motor power
cable, reset the lift motor incline level to 10 and repeat the Lift Motor Yoke cal-
ibration.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 128
6 Replacement Procedures
Lift Motor Replacement
