7. Reattach the Yoke to the Ramp using the two fasteners, torque to 330 in-lbs (27.5 ft-lbs
or 37.2 Nm).
8. Remove any blocking materials and/or pads.
9. Reconnect the Lift Motor input power/control cable.
10. Access the service menu diagnostic
CrossRamp Test
and operate the ramp incline
level through the full range of motion from minimum to maximum levels and verify oper-
ation:
l
P10, P30, P30i and P31: (
Service menu (51765761)
>
MACHINE TEST
>
CROSSRAMP TEST
.
l
P62, P80, and P82: (
Service menu (51765761)
>
System Settings
>
System
Tests
>
CrossRamp Test
.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 130
6 Replacement Procedures
Lift Motor Replacement