1. Remove the Top Lift cover, see
.
2. Use a 3/16" hex key to remove the Fixed Arm Mounting Bar -
inner
and
outer
Nylock
set screws. Do not loosen and then retighten the Nylock set screw, this will damage the
Nylock patch. Discard and do not reuse the Nylock set screws.
CAUTION
: Do not reuse the
inner
or
outer
Nylock patch set screws for installation.
Either removing or loosening the Nylock set screw will compromise the integrity of
the Nylock patch. Discard and order new set screws for installation (see
, bubble # 252).
2. Remove the two 5/32" hex key Handlebar Mounting Clamp fasteners located at the
front top of the console mount weldment. Hold arm while removing clamp.
3. Carefully remove the fixed arm mounting spud from the mounting bar.
4. Repeat procedure for both left and right Fixed Arms.
Installation Instructions
1. Reinstall the Fixed Arm onto Fixed Arm Mounting Bar and the Handlebar mounting
bracket.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 141
6 Replacement Procedures
Fixed Arms Replacement