2. Position the Fixed arm into the Handlebar Mounting Bracket. Secure using the Handle-
bar Mount Clamp and two 5/32" hex key fasteners. Fully tighten and torque fasteners to
144 in-lbs (16.3 Nm).
3. Reinstall the
Inner
and
Outer
3/16" hex key Nylock set screws, torque fasteners to 300
in-lbs (34 Nm)
CAUTION
: Do not reuse the
inner
or
outer
Nylock patch set screws for installation.
Either removing or loosening the Nylock set screw will compromise the integrity of
the Nylock patch. Discard and order new set screws for installation (see
, bubble # 252).
4. Repeat procedure for both left and right handle bars.
5. Verify machine operation and return to service, see
.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 142
6 Replacement Procedures
Fixed Arms Replacement