f. Remove the Pivot Block flat washer and wave washer off the Crank Spindle.
Note that the wave washer sets against the Crank. Retain part(s) and/or fastener
(s) for installation.
2. Roll the wheels down the track and off the back of the ramp.
Stairarm Linkarm Removal
3. Remove the Linkarm from the Stairarm (moving arm models only):
a. Remove the #2 Phillips screw fastener and remove the Outer Linkarm Cover.
Retain part(s) and/or fastener(s) for installation.
b. Remove the 9/16" hex head screw and remove the Linkarm from the Stairarm
weldment - Linkarm bracket and carefully lay onto the floor.
c. Remove the Inner Linkarm cover from the Stairarm weldment - Linkarm bracket.
Retain hardware and fastener for installation.
Installation Instructions
Stairarm Linkarm Installation
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 154
6 Replacement Procedures
Stairarm Replacement