System Component
Specification
Plastite screw fasteners
20 in-lbs (2.3 Nm)
Flathead screws
25 in-lbs (2.8 Nm)
Input Drive Assembly fastener
180 in-lbs (20.3 Nm)
Step-up Pulley/Tensioner and Tension Assy fasteners
180 in-lbs +/- 54 (20.3 +/_ 4.5
Nm)
Generator/Eddy Brake Assy fasteners
180 in-lbs +/- 54 (20.3 +/_ 4.5
Nm)
Linkarm fasteners
300 +/- 90 in-lbs (34 +/- 10 Nm)
Crank Retention Plate Fastener
30 +/- 9 in-lbs (3.4 +/- 1 Nm)
Yoke Ramp bolts
330 in-lbs (27.5 ft-lbs or 37.2 Nm)
Belt Tension Specification
.Drive belt tension specification:
System Component
Specification
First Stage Drive Belt Tension - New Belt
(1)
140-150 lbs (63.5 - 68 kgs)
First Stage Drive Belt Tension - Used Belt
(1)
125 - 135 lbs (56.7 - 61 Kgs)
Second Stage Drive Belt Tension - New Belt
(1)
110-120 lbs (50- 54.4 kgs)
Second Stage Drive Belt Tension - Used Belt
(1)
92 - 105 lbs (43 - 47.6 kgs)
(1) New belt tension applies to new belt first time installations. Used belt tension applies to
reinstalling an existing belt or re-tensioning an existing used belt.
.
Bolt Grade Identification
(missing or bad snippet)
Parts
IMPORTANT
: Always purchase OEM replacement parts and hardware from Precor.
If you use parts not approved by Precor, you could void the Precor Limited Warranty.
Use of parts not approved by Precor may cause injury.
Exploded View Diagram and Parts List
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 11
2 General Information
Bolt Grade Identification
