INFORMATION DISPLAY
DESCRIPTION
Belt condition based on typical input current values:
Normal: 8 -12 A (120Vac) / 4 - 6 A (240Vac)
Worn: ≥ 16 A (120Vac) / ≥ 8A (240Vac)
Replace: ≥ 18 A (120Vac) / ≥ 9A (240Vac)
Max Amps: 20 A (120Vac) / 10A (240Vac)
U-BOOT SW
The console Upper Boot software version information.
U-BASE SW
The console Upper Base software version information.
METRICS BOARD SW
The console Metrics board software version information
L-MAJOR SW
The
LPCA
1
Major processor software version inform-
ation.
L-MINOR SW
The LPCA Minor processor software version information.
Note: The Minor software versions can only be viewed
while the user is pedaling. If the user is NOT pedaling,
then the software will be displayed as “--------------“.
L-ASL SW
(1)
The LPCA Active Status Light processor software version
information.
SER NUMBER
Displays the model and serial number of the machine. The
base serial number can be set using the WinCSAFE com-
puter software. The factory default is NONE.
USAGE LOG
Displays the type of workout programs the users are
accessing most frequently.
"Error Log & CPA Event Log"
on page 185
Table of stored error event codes.
TIP
: You can quickly access the Error log by holding down
the
PAUSE
key. Will show the
STUCK KEY
message
when there are no logged error codes.
(1) Only used on products with the ASL feature. Not included on the EFX600 series, the
TRM600 series, or the TRM800-10 (TRM10/GEN06) series products.
(2) TRM600 series treadmills only.
1
Lower printed circuit assembly; generally this refers to the lower board. On treadmills, this is
the motor controller unit (MCU), and on self-powered units, it is the main board in the lower
section.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 30
4 Standard Service Menus
LED Console Standard Service Menus