c. Then use the crank to rotate the input pulley a couple of rotations to seat the belt
and remeasure the belt tension.
d. If the belt tension is not within specification, repeat the tension adjustment pro-
cess until the belt tension is correctly tensioned.
7. Use a 1/2" socket to tighten the two Drive Components assembly carriage bolts (left
side), torque bolts to 180 in-lbs +/- 54 (20.3 +/_ 4.5 Nm).
8. Measure and verify that the second-stage drive belt is within specification, retention the
belt as needed, see
"Second Stage Drive Belt Tension Adjustment" on the facing page
.
9. Reinstall the left Drive Disk cove, see
10. Reinstall the Drive Access Panel, see
.
11. Verify machine operation and return to service, see
"Operation Verification" on page 14
See Also
"Second Stage Drive Belt Tension Adjustment" on the facing page
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 48
5 Adjustment Procedures
First Stage Drive Belt Tension Adjustment