9. Reattach the Yoke to the Ramp using the two yoke ramp fasteners, torque to 330 in-lbs
(27.5 ft-lbs or 37.2 Nm).
10. Remove any blocking materials and pad.
11. Reconnect the lift motor input power cable.
12. .Verify the crossramp incline operation through the full range of motion, levels 1 thru 20.
Access the
CROSSRAMP TEST
diagnostic test and then lower and raise the cross-
ramp incline several times from the minimum to maximum levels.
a. .On LED (P10, P30, P30i and P31) consoles: Access diagnostic test menu
(51765761) and select
MACHINE TEST
>
CROSSRAMP TEST
.
b. .On Touchscreen (P62, P80, and P82) consoles: Access the Service menu
(51765761) and select
System Settings > Systems Test
>
CrossRamp Test
.
13. Reinstall the Front Lift, Lift Interface Plate, and Ramp covers, see
and
procedures.
14. Verify elliptical operation and return to service, see
"Operation Verification" on page 14
.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 56
5 Adjustment Procedures
Lift Motor Calibration