Scotch-Bright pad (or fine steel wool). Dry ramp track surfaces with a clean rag.
2. Reinstall ramp cover
by inserting the rear tabs into the rear ramp platform mounting
clips and then pressing down (and/or using the palm of your hand to lightly strike the top
of the ramp) on the top front of the ramp to snap into the front bracket clip. Verify that the
ramp clips are correctly engaged by grabbing the ramp sides and gently attempting to
move and lift the ramp off the platform.
3. Secure ramp
by reinstalling the #3 Phillips screw fastener and fully tighten.
4. Reinstall the left and right Stairarm wheel trucks onto the Ramp tracks. To install, slip
the top of the wheels underneath the CrossRamp cover while lifting the bottom of the
wheels over and into the CrossRamp track. You may need to slightly lift up the edge of
the CrossRamp cover while inserting the wheels into the CrossRamp track.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 71
6 Replacement Procedures
Covers and Panels Replacement