2. Rotate the crank until one of the two Drive Disk cove attachment screw holes can be
seen through the drive cover fastener cutout. Then install the #2 Phillips screw and fully
tighten. Move the crank to the second attachment screw hole and install the second
screw. If the second screw is missing, order a new screw and install (two fastener
screws (two per side are required), see
, bubble #155.
Note
: Some early production units were shipped with only one disk cover attachment
screw. Two cover crank fasteners are now required. If missing screws, order addi-
tional screw, see
, bubble #155.
2. Reinstall the Drive Access panel, see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 77
6 Replacement Procedures
Covers and Panels Replacement