Lift motor power
Lift motor power is supplied by the battery thru the lift motor fuse located on the
LPCA
1
board,
see
"LPCA Fuse Locations" on page 135
Procedure
Review entire procedure before starting.
Removal Instructions
1. Remove the Front Lift cover, Lift Interface Plate cover, and Ramp cover, see
,
, and
.
2. Place a protective pad over the top of the Front Frame Cover underneath the Ramp to
protect the cover surface while doing this procedure.
3. If the lift motor is working, access the
CrossRamp Test
diagnostic test and raise the
incline level to 10
1
Lower printed circuit assembly; generally this refers to the lower board. On treadmills, this is
the motor controller unit (MCU), and on self-powered units, it is the main board in the lower
section.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 125
6 Replacement Procedures
Lift Motor Replacement