The optional AC Power Adapter is an 18 Vdc 3 Amp power supply that provides two dif-
ferent functions depending on whether the bike has the initial first release or the updated
second release of the AutoCal software.
1.
Power supply
: On bikes with the initial first release of the AutoCal,
LPCA
1
SW ver-
sion 303713-101 or 102, the AC Power Adapter is used as an alternative method to
power the LPCA board and console. Very helpful when you need to use the console
for extended periods of time, such as when configuring settings or updating software.
2.
To enable a manual AutoCal
: On bikes with updated second release of the
AutoCal, LPCA SW version 303713-103 and later, the AC Power Adapter is also used
to enable manual AutoCal calibrations, see
.
IMPORTANT
: On bikes with the updated AutoCal release 2,
do not
leave the AC
Power Adapter plugged in during normal operation. Plugging in the AC Power
Adapter will enable the manual AutoCal function, if the pedals are spun above 55
rpm the bike will do an AutoCal when the pedals stop.
Installation
: The AC Power Adapter plugs into the LPCA Power Adapter input port located
on the bottom edge of the card (orientation as installed).
Lubrication
Lubricants
Only use products from the following list of approved lubricants:
1
Lower Printed Circuit Assembly board; also refered to as the Lower PCA or simply as the
lower board. On treadmills, it is the console to base function interface and the motor con-
troller unit (MCU). On self-powered units, it is the lower PCA console to base function inter-
face.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 11
2 General Information
Lubrication
