1. Use a crank puller (recommended Park Tool CCP-222 to pull the crank arm from the
bottom bracket bearing axle and remove.
2. Remove the bottom bracket cover.
Note
: Early production bikes may not include the bottom bracket cover, see service
bulletin SB.SBK.20160825 for information.
3. Remove the bottom bracket axle 36 mm nut. Clean the axle nut and the bottom bracket
axle threads. Retain fastener hardware for installation.
4. Repeat steps to remove the right crank arm.
Installation instructions:
1. Apply a light coat of multipurpose oil to the 36 mm axle nut threads and install onto the
bottom bracket axle. Fully tighten the axle nut.
106
5 Replacement Procedures
Crank Arm Replacement