1. Center the stabilizer attachment bar into the rear stabilizer weldment bracket.
2. Position the rear stabilizer onto the frame weldment and secure using the two 6 mm hex
key stabilizer mounting bolts (2x) and washers (2x) , torque to 15.6 ft-lbs (21 N•m).
CAUTION
: Do not over tighten fasteners. The bolt heads can snap off if over
tightened.
3. Install the two rear stabilizer leveling feet.
4. Return bike to the upright position.
5. Make sure the bike is level and setting firmly on the floor, see
6. Verify bike operation per the
"Operation Verification Checklist" on page 7
and return to
service.
See Also
"Front Stabilizer Replacement" on page 115
"Bike Leveling Adjustment" on page 27
120
5 Replacement Procedures
Stabilizer Replacement