3. Remove the flywheel which also requires removing the LPCA board, the cross mem-
ber, drive belt, and generator belt, see
"Drive Belt, Generator Belt, and Flywheel
.
4. Carefully cut and remove the data COMM and strain gauge cables from the lower right
fork weldment push-mount-cable-tie (1x). Remove and discard the
push-mount-cable-tie (the lower push-mount-cable-tie is located on the inside of the
right fork weldment adjacent to the top of the cross member mounting bracket.
5. Remove the four 4 mm (4x) hex key bolts and remove the console backplate cover. Dis-
connect the data COMM cable from the console and set the console aside, see the
"SPINNER
®
CHRONO™ CONSOLE"
57