General Information
The following information provides general equipment and service information that will help
you to use this manual to properly repair and maintain the treadmill.
Features
The equipment operating specifications.
Feature
Specification
Consoles
R20 and R40 consoles
*R40 supports smart phone charging.
Incline
Elevation system generates up to 1000 lb / 453.6 kg of thrust and
operated in compression for reliable operation.
Range: 2% Decline - 15% Incline
Levels: 0 - 15
Speed
Range: 0.0 - 12 mph in 0.5 increments (0.0 - 19.3 kph in 0.1 kph
increments)
Belt/Deck
The running belt is lubricated, the deck is reversible and not lub-
ricated..
Running surface: 22" x 56" (56 x 142 cm)
Drive Motor
3 hp 120 Volt
DC
1
continuous duty motor.
The motor controller (
MC
2
) implements Integrated Foot Plant
Technology™ and Pulse Width Modulated (PWM) drive tech-
nology for high reliability and accurate speed control.
Emergency Stop
(
ESTOP
3
)
Exersicer safety clip and lanyard connected to the stop switch to
immediately switch off power bringing the treadmill to a stop.
Heart Rate
Two Heart Rate sensor types:
l
Touch Handheld Handlebar Heart Rate sensors (
HHHR
4
).
1
Direct Current: electrical current that only flows in one direction.
2
Motor controller, motor controller unit, or motor controller module: used on treadmills, con-
tains the LPCA and motor controller functionality.
3
Emergency Stop: Safety clip and lanyard attached to the stop switch to immediately turn
off power bringing the treadmill to a stop.
4
Handheld Handlebar Heart Rate
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 5
2 General Information
Features