DOs
1. Place PREETHI at a convenient height for easy operation.
2. Ensure that PREETHI is placed on an even, smooth, hard and clean
surface. (otherwise dust will be sucked up through the Bottom Plate
and the unit will be unstable.)
3. Make sure the Stainless Steel Jars are clean and dry.
4. Ensure that the Dome Gasket is properly fitted to the Dome and that
the assembly is firmly seated in the Jar (use the Dome Lid for sealing
the Dome) before operating the unit.
5. Ensure that the Locks of the Stainless Steel Jar are properly seated
in the Grooves provided inside the Top Cap.
6. Hold the Dome gently while operating. Keep Dome and Lid fixed on
the Jar at all times, to prevent contents from spilling out.
7. While adding ingredients, remove the Dome Lid and use the
opening in the Dome.
8. When operating the unit for the first time, or after long storage, or
when the unit has been shifted over a long distance, rotate the Motor
Shaft by hand through the Motor Coupler, until the Motor Shaft
rotates freely.
9. Unplug from Power source before fixing, removing attachments
and also while cleaning or when not in use.
10. Keep PREETHI away from children.
11. Keep the unit away from direct heat and sunlight.
12. Give Dry Grinding jobs over Wet Grinding, to reduce the necessity of
repeated cleaning.
DON’Ts
1. Do not operate unless Jar and Dome are in proper position.
2. Do not remove Jar assembly before the Blade comes to a complete
stop, after switching off the Motor.
3. Do not put your hand inside the Jar, when the Mixie is running.
4. Do not touch moving parts or remove any attachments, while the
Motor is running.
5. Do not run the Motor without any Load.
6. Do not burden the Motor with loads heavier than the specified
capacity given in our instructions.
7. The Motor is not to be run for more than 30 minutes at a stretch. (No
operation takes more than 3 minutes if instructions are properly
followed).
When hot air emanates from the openings on the Top Cap, switch off
the Motor and wait for 3 minutes, before re-starting.
8. Do not allow the turning of the Blades to slow down. When Wet
Grinding, ensure proper circulation is maintained. If not, stop, stir,
add liquid and then run the Motor.
9. Do not add solid ingredients, when the Motor is running.
10. Do not operate with damaged Plug and Cord.
11. Do not tamper or attempt to repair PREETHI.
In the event of the unit needing attention, take it to one of our
Customer Care Centre.
(Refer Page 8)
12. Do not grind hot ingredients in the Mixie.
13.
Do not use the Mincer Blade for operations other than
mincing.
6
