Chronoskop CHR-9 Timegrapher
User manual
www.CHRONOSKOP.com
15
3.6. Starting the measurement and the buttons
When starting a measurement from the main menu, you are automatically guided to the
measurement with numerical values view. After a periodic signal has been detected, the
actual measurement begins. If an error occurs during the measurement or if no periodical
signal has been detected (yet), the red lamp will light up. During the measurement it is
possible to switch between the display modes arbitrarily. The buttons serve:
Numerical values view
Diagram view
Long-Time behavior view
Impulse analysis view
Further buttons are:
Restart the measurement.
This deletes all measured values and restarts measurement.
Amplitude measurement: automatic / manual
You can choose between automatic or manual determination of the lifting time
of the balance
T
H
(see Theoretical Basics), which is necessary for the calculation of the
amplitude. With manual amplitude measurement, you can limit the lifting time of the balance
by moving the brackets in the Impulse Analysis view.
Exit
Exits the measurement and returns to the main menu.
