TRANSMITTER SETUP
WARNING
The Aura 8 AFCS is designed to work seamlessly with all major transmitter and receiver brands. When programming your transmitter, start
with a freshly reset new model memory in your transmitter.
Make ONLY the changes shown in the Transmitter Configuration Guide
unless otherwise noted.
The Aura 8 in the QQ Extra 300G2 defaults to 3 flight modes that are switched via CH5/Gear in your transmitter. You may need to reassign
CH5/Gear to a 3-position switch.
The LEDs in the Night QQ Extra 300G2 are switchable on/off via CH6/Aux 1 in your transmitter. You may need to reassign CH6/Aux 1 to a
2-position switch.
Consult your transmitter manual if you have questions on how to change the switch or channel assignments.
The Aura comes pre-programmed with dual rates and expos specifically designed for the QQ Extra 300G2. For large (greater than 5%)
changes in expo or dual rates, it is highly recommended to reset all expos and rates to default in the transmitter, and tune through the Aura
Config Tool.
The Aura Config Tool is free to dowload, and can be used on any Windows-based PC or tablet. Download at:
www.flexinnovations.com/AuraConfigTool
DO NOT ATTEMPT RADIO SETUP WITH PROPELLER INSTALLED. INADVERTENT POWER UP COULD CAUSE
DEATH OR SERIOUS INJURY.
8
TRANSMITTER CONFIGURATION GUIDE
End Points
(Travel Adjust
or ATV)
Ail/Ele/Rud
Thro/Gear/Aux1
125%
100%
Sub Trim
Verify at zero, NOT ALLOWED
Trim Levers
Verify at zero
CH. 5 (Gear)
Assigned to a 3-position switch
Reversing
None Required
2
Timer
4
Wing/Tail Type
Normal - 1 Ail, 1 Ele, 1 Rud
CH. 6 (Aux1)
Assigned to a 2-pos. switch (for LEDs)
3
Spektrum, Futaba & Graupner
JR DMSS
1
Ail/Ele/Rud
Thro/Gear/Aux1
Verify at zero, NOT ALLOWED
Verify at zero
Assigned to a 3-position switch
None Required
Set to 3:30 for initial flights
Normal - 1 Ail, 1 Ele, 1 Rud
Assigned to a 2-pos. switch (for LEDs)
3
88%
88%
JR transmitter users that use Spektrum DSM2/DSMX receivers should follow the Spektrum information in the chart
above.
If you are using a Futaba transmitter, please note that some Futaba transmitters have the throttle set to reversed by
default. Leave reversing set to defaults to start, and reverse as needed.
This is only required to switch the LEDs on/off via the transmitter. If the LED controller is unplugged from the receiver
or Aura 8, the lights default in the ON position when powered.
The QQ Extra 300G2 can fly anywhere between 3 and 6 minutes (w/3S 2200mAh Li-Po), depending on flying style.
1.
2.
3.
4.
NOTICE
FOR CUSTOMERS USING TRANSMITTERS OTHER THAN WHAT IS LISTED IN THE CHART ABOVE, PLEASE VISIT
OUR WIKI PAGE FOR INSTRUCTIONS SPECIFIC TO YOUR TRANSMITTER AND RECEIVER BRAND
JETI
HITEC
FRSKY
wiki.flexinnovations.com/wiki/Aura/JetiUse
wiki.flexinnovations.com/wiki/Aura/HitecSbusUse
wiki.flexinnovations.com/wiki/Aura/FrSkyUse
Summary of Contents for QQ EXTRA 300G2
Page 1: ...Day Night Versions Day Night Versions G2 G2 ...
Page 2: ......
