background image

P.4

 User 

Guide

 

Panic Mode will automatically shut off after 30 seconds. 

Note: 

If you want to stop Panic Mode before the 30-second delay, press the 

LOCK

 or 

UNLOCK 

button. 

Quick Lockout

TM

 

(Also called 

Secure Panic

.) For fast protection, the system will lock all doors when you 

press the 

brake pedal while the horn is activated and the system is in Panic Mode

. (Quick Lockout is 

only available when Panic Mode has been activated.) 

Cold Weather Mode 

When the Cold Weather Mode is active, the engine starts every 2 hours and runs for 4 minutes (or 

for 9 or 20 minutes with Diesel engines); this routine will go for a period of 24 hours. 

To e n t e r  Cold Weather Mode:  

 

Press and hold the 

START/STOP

 button for 3 seconds until the Parking Lights flash 3 times. 

To check whether the system is in Cold Weather Mode: 

 

Press the brake pedal: the parking lights should stay on until the brake pedal is released. 

If Safe Start is enabled, you can activate Cold Weather Mode by 

 

Pressing the 

START/STOP

 button, and then 

 

Pressing and holding the 

START/STOP

 button again until the parking lights flash 3 times. 

To  e x i t   Cold Weather Mode, do any one of the following: 

 

Open the hood. 

 

Start the engine using the remote control. 

 

Turn the ignition key to the 

IGNITION ON

 

(

RUN

) position. 

 

Turn on the Valet Mode. 

In 

Safe Start 

Mode: 

 

Press and hold the 

START/STOP

 button twice within 3 seconds 

… until the parking lights flash once. 

In standard mode: 

 

Press and hold the 

START/STOP

 button for 3 seconds until the parking lights flash once. 

Remote Door Locks 

If your system was installed with the Remote Door Locks option, you will have the convenience of 

remote keyless entry. 

To  u n l o c k   your doors and  d i s a r m   the Starter Kill: 

1.

 

Press and hold the 

UNLOCK

 button for approx. 1 sec. 

2.

 

The parking lights will flash twice and the LED will turn off to confirm that the doors have been 

unlocked and that the Starter Kill feature is disarmed if it was installed. 

To l o c k  your doors and a r m  the Starter Kill: 

1.

 

Press and hold the 

LOCK

 button for approx. 1 sec. 

2.

 

The parking lights will flash once and the LED will flash slowly to confirm that the doors have 

been locked and that the Starter Kill feature is enabled if it was installed. 

Priority Door Access 

When programmed, this safety feature lets you unlock solely the driver’s door with a single press of 

the 

UNLOCK

 button on the transmitter; upon a second press of the 

UNLOCK

 button, all the other 

doors will unlock. 

Arming the Starter Kill 

If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm automatically) or 

in Passive Mode (will arm automatically). See p. 5 for more details on arming modes. 

 

To 

disarm 

the Starter Kill in Active or Passive Mode, press the 

UNLOCK

 button on the trans-

mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will also un-

lock the doors.)   

Summary of Contents for PD-TWO.5SH









Reviews: