Don't Be Afraid Of The Dark...
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship. Akron Brass will repair or replace product
which fails to satisfy this warranty. Repair or replacement shall be at the discretion of Akron Brass. Products must be promptly returned to Akron Brass for warranty service.
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow our
instructions or recommendations; or anything else beyond our control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOS INCLUDED IN THIS WARRANTY STATEMENT, AND
WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Further, we will not be responsible for any consequential, incidental or indirect
damage (included, but not limited to, any loss or profits) from any cause whatsoever. No person has authority to change this warranty.
PHONE: 330.264.5678 or 800.228.1161 FAX:330.264.2944 or 800.531.7335 www.akronbrass.com
A Premier Farnell Company
17a
There will be three (four) wires coming out of
the center hub, Black (hot),
(Red if a 4 wire
reel is purchased - Hot)
White (common) and
Green (ground) and each is equipped with a
10-12 yellow butt connector attached to each
wire.
17b
On YOUR CORD SET prepare one end of your
cord by taking about 4" of the outside insulation
off making sure that you do not cut through or
into the three inside wires. Remove inside
fillers, leaving three number 10 or 12 wires.
17c
17d
Cut back the ends to match the offset on
the wires from the cord reel hub. Now
strip the insulation off the three (four)
wires and twist the ends so there are no
loose strands.
Slip your prepared cord set end through
the rubber coated cable clamp and slide
the 6" piece of shrink tubing over your cord
set end.
Connect the Black, White and Green
wires from your cord set to the three
matching colored wires exiting the
cord reel's center hub.
(Red if a 4
wire reel is purchased.)
Hand crimp
each connection with heavy duty wire
crimps designed for crimping. Make
sure that there are no loose wires or
wire strands around the butt
connectors.
17e
17f
Slide the shrink tube down your cord
set wire and over the three butt
connectors to the reel hub.
17g
17h
With a heat gun carefully shrink the
black tube around both wires until
tight.
Do Not
burn the reel disk or
wire connections or melt the center
hub of the reel with your heat source.
Tighten up the cable clamp. The
clamp is to be tight on your cord set
end ahead of the butt connectors.
Wiring of the hub is the same as wiring the portable reels
Page 34
