SBC-EC9100 User Manual
Embest Technology Co. Ltd
|
http://www.embest-tech.com
20
ci_hdrc ci_hdrc.0: USB 2.0 started, EHCI 1.00
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
usb 1-1: new high-speed USB device number 2 using ci_hdrc
usb-storage 1-1:1.0: USB Mass Storage device detected
scsi1 : usb-storage 1-1:1.0
scsi 1:0:0:0: Direct-Access Generic Flash Disk 8.07 PQ: 0 ANSI: 4
sd 1:0:0:0: [sda] 7823360 512-byte logical blocks: (4.00 GB/3.73 GiB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1
sd 1:0:0:0: [sda] Attached SCSI removable disk
2.12.2.2
Keyboard
USB Keyboard:
usb 1-1: new low-speed USB device number 4 using ci_hdrc
input: SIGMACH1P USB Keykoard as
/devices/soc0/soc.0/2100000.aips-bus/2184000.usb/ci_hdrc.0/usb1/1-1/1-1:1.0/0003:1C4F:0002.0003/input/inp
ut4
hid-generic 0003:1C4F:0002.0003: input: USB HID v1.10 Keyboard [SIGMACH1P USB Keykoard] on
usb-ci_hdrc.0-1/input0
input: SIGMACH1P USB Keykoard as
/devices/soc0/soc.0/2100000.aips-bus/2184000.usb/ci_hdrc.0/usb1/1-1/1-1:1.1/0003:1C4F:0002.0004/input/inp
ut5
hid-generic 0003:1C4F:0002.0004: input: USB HID v1.10 Device [SIGMACH1P USB Keykoard] on
usb-ci_hdrc.0-1/input1
2.12.2.3
Slave Device
Connect J7 to PC, open the device manager, and check if the following device is recognized:
