SBC-EC9100 User Manual
Embest Technology Co. Ltd
|
http://www.embest-tech.com
17
0 0 0 0 0 0
RX: bytes packets errors dropped overrun mcast
0 0 0 0 0 0
TX: bytes packets errors dropped carrier collsns
7 1 0 0 0 0
Note: Two CAN modules master be set at the same baudrate.
2.11
Network
Execute the following instructions on the serial terminal:
Configure the IP address:
root@embest:~# ifconfig eth0 192.168.2.64
Testing network interface:
root@embest:~# ping 192.168.2.1
2.12
USB
2.12.1
Host
2.12.1.1
U-disk
Insert the U-disk to the USB Host interface (J8), serial terminal will display the disk information:
usb 2-1: USB disconnect, device number 3
usb 2-1: new high-speed USB device number 4 using ci_hdrc
usb-storage 2-1:1.0: USB Mass Storage device detected
scsi0 : usb-storage 2-1:1.0
scsi 0:0:0:0: Direct-Access Generic Flash Disk 8.07 PQ: 0 ANSI: 4
sd 0:0:0:0: [sda] 7823360 512-byte logical blocks: (4.00 GB/3.73 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1
sd 0:0:0:0: [sda] Attached SCSI removable disk
Execute the following instructions on the serial terminal:
root@embest:~# ls /dev/sd*
