Page 16
Installation Instructions
Troubleshooting Procedures
Symptom
Check
Try
The lift does not run.
Is the main connected to the control box?
Are all the plugs mounted correctly in the control box?
Is there any visible damage to the cables, controls, or
the control box?
Try to connect a lamp to the main power supply to check
that the supply voltage is functioning.
Check all connections.
Damaged parts must be exchanged (contact your vendor).
Is the lift in the fully extracted position?
Is there any load on the lift compared to when the lift
functions normally?
When the lift has reached its upper position it can only run
downwards.
Remove any load and try again.
The lift stops and can only
operate in the opposite
direction.
The lift will only run down-
ward even though the lift is not
overloaded.
Perform Basic Setting (see Owner’s Manual that came
packaged with the lift).
The lift does not run with full
stroke length upwards. It always
stops at the same position.
The system has set a new start/stop program.
Perform Basic Setting (see Owner’s Manual that came
packaged with the lift).
The lift does not run at all. No
movement is observed.
Defective handset or control box.
Poor connection.
Main cable has been disconnected.
No voltage on the main cable.
Check all connections. Check that there is voltage at the
main plug. Connect a handset that you know functions
correctly. If the lift runs, than the handset is defective. If
this does not work, than the control box is defective.
The lift is in the down position
and will not go up.
The lift is overloaded.
The cable between the lift and the control box is not
OK.
Remove some of the load from the lift.
Perform Basic Setting (see Owner’s Manual that came
packaged with the lift). If Basic Setting does not work,
exchange the cable.
L180F
Step 1.
Once lift is completely installed, lower the lift to its closed position and release the down ( ) button.
Step 2.
Press and hold the down ( ) button until the lift resets.
Step 3.
Press the up ( ) button and monitor the lift as it moves up.
Step 4.
Once the lift has reached the desired height, stop it by pressing the down ( ) button.
Step 5.
Press the down ( ) button again to lower the lift.
Step 6.
The programming phase is complete once the lift is in the lowered position.
Step 7.
The lift should only be controlled by the remote at this point. If the buttons on the manual switch are pressed again, it will reset
the lift and the height setting will be lost. If this happens, run the previous steps again to re-program.
Programming Lift Height (Optional)
You can program the travel height of the lift using the optional remote. To do this, please refer to the following instructions.
