4
Model PT-F110 / F110B:
• Remove the lower bracket at the base on the right side of the door;
• Remove the door from the housing and remove the screws located under the top of the fridge (On
the front right side);
• Invert the upper housing in the opposite holes, insert the door after removing the plugs of the left
holes and screw the lower bracket.
OPERATING YOUR REFRIGERATOR
Setting the Temperature Control
•
To control the internal temperature, adjust the control dial according to the ambient
temperature or purpose of use.
•
The first time you turn the unit on, set the temperature control to “6.”
•
The temperature control range is from "OFF" to "6". After 24-48 hours from the first power on
of the refrigerator, adjust the temperature control to the setting that best meets your needs
taking into account that temperatures vary from 8 ° / 6 ° degrees in minimum setting "1" up to
a maximum of 2 ° degrees in setting "6" of the control dial easily adjustable by turning the
knob inside the refrigerator compartment. The "3" setting of about 4 degrees should be
appropriate for use in the home or office.
•
NOTE: If the unit is unplugged, has lost power, or is turned off; you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the refrigerator will
not start.
•
Use of the Ice Cube Tray
•
For your ice requirements, fill approximately ¾ of the tray after washing it.
•
If you want to make ice cubes quick, set thermostat to
position “6”.
•
To release the ice cubes, hold the tray upside down and twist slightly at
both ends until the pieces of ice fall.
Adjusting the feet
To level the feet on the front of the appliance base simply rotate the feet manually to the right or left,
until the desired height is reached. In this way they can be adjusted according to your needs.
TIP
: If the front of the refrigerator is slightly higher than the back, the door will open and close more
easily.
