5. ATTACH CABINET TO STUDS
Using the pre-drilled holes in top of
cabinet, attach unit to studs with two
#10 x 1
1/2
” screws for top installation.
Locate side ironing board brackets
that are secured to cabinet with
three screws.
Then remove the
top screw from each bracket.
This
is where the bottom part of your
cabinet will be secured to the studs.
6. REMOVE BRACKET SCREW
Example shown with studs
to illustrate mounting.
4. INSTALL UNIT IN WALL
Begin installation by carefully lifting unit
into the wall opening. Make sure the
cabinet is plumb and level. If needed,
add shims to help unit fit snug in place.
8. INSTALLATION COMPLETE!
Cabinet is now fully installed! If desired,
decorative trim or molding may be
added to cover any irregularities in the
wall.
Pre-drill holes into the cabinet using
the holes in side brackets where
screws were just removed.
Finish installation by screwing the
two #14 x 2
1/2
” screws into the
pre-drilled holes to secure bottom
part of cabinet into the cabinet.
7. PRE-DRILL HOLES IN SIDES
