2. Basic Operation
2.1 Power ON/OFF
- Insert the power cord into the appropriate socket.
- Press the
Power switch
to switch on the TV, then press
Power
button to
turn on the unit.
- Press the
Power switch
again to switch off the TV.
Note: After switch off the TV, please don’t immediately re-open the power
switch ,should be delayed one minute or more to re-open the power
switch.
2.2 Setting of Standby Mode
- Press (
) button to turn on the unit.
- Press (
) button again to return the display to standby mode. The
power indicator turns red.
- Be sure not to set your TV in standby mode for a long period of time.
2.3 Selection of Input Mode
- Press the
Source
button
,
and then press
or
to select the signal
source you desire, then press
Enter
or
button to confirm .
The signal sources are displayed in the following sequence:
1.6 Installation of Batteries
1. Open the back lid of the remote control.
2. Install two 7#(AAA)1.5V batteries.
Ensure the correct polarity of the batteries.
3. Cover the back lid.
Please take out of the batteries from the remote
control for long time of no use.
If the remote control doesn't work properly,
please carry out the following checks.
- Check the TV is turned on.
- Check the polarity of the batteries are correct.
- Check the batteries are not drained.
- Check the power supply is normal or the power cord
is correctly connected.
- Check there are no special fluorescent light or neon
light around.
WWW PREMIERMUNDO COM
Page 10