3-6
Eyepiece guards
1) For user who does not wear glasses, the use of the rubber eyepiece guards will help avoid
glare from any incidental lighting in the room. Fit the rubber eyeguards over the eyepieces
with the deeper edge to the outside of observer’s face.
2) For user who wears glasses, do not install the eyeguards.
3-7
Using Trinocular featu re Model S MZ -07
With Model
SMZ-07
, you can alternate use of the binocular observation with trinocular use of
the third eyetube by installing an eyepiece (not included) or video or digital camera attachment
(sold separately) into the third eyetube. Unscrew the cover from the tube socket and install the
third tube by screwing the tube into place. To obtain the image through this third tube you must
slide out the silver pole to the left of the head. (It is normal for the left eyepiece of the binocular
head to be dark at this point.) Be sure to slide the pole out completely until it stops (approx. ¾”).
(see Fig.7) Refer to manufacturers’ instructions for use of camera with the stereo zoom scope.
3-8
Adjusting the brightne ss of the lam ps
Turn the variable control light knob
①
according to the sign
marked on the base, turning clockwise to increase the brightness,
counter-clockwise to dim. (Fig.8)
Note
: Model
SMZ-07
is
equipped with a Fluorescent lamp in the bottom light and is not
adjustable.
3-9
R eplacing th e lam ps
Note:
Before replacing the lamps, turn off and disconnect the
power.
1) Slide the clips aside and carefully remove the glass stage plate.
(Fig.9)
2)
①
Gently remove the lamp from the socket. (Allow a hot bulb to
cool before removing.)
3) Put a new lamp into the socket, be sure it is inserted completely.
Do not touch the new bulb with bare hands as body oils may damage
it.
4) Replace the stage plate. (Fig.10)
3-10
Repl acing the fus e
1) Remove the fuse tube with a screwdriver and then pull the fuse
out of the tube
①
.
(Fig. 11)
2) Replace the fuse and remount it in the fuse holder. (Fig.11)
Figure 9
Figure 10
Figure 11
Figure 8
