2
FIXTURE COMPONENTS
The LED Wraparound consists of three components: the housing (A) diffuser (C), and end
pieces (D).
HOW TO INSTALL THE WRAPAROUND
1.
Insert the two Small Pin Cross Machine
Screws (AA) into the junction box. Do not
tighten.
2.
Remove the diffuser (C) Do this by
removing the two screws attached to an
end piece (D), then sliding the diffuser out.
3.
Connect the ground wire from the
junction box to the yellow/green ground
wire of the fixture, the white wire to the
white, and the black wire to the black.
For each, place Wire Nuts (BB) over the
connected wires and twist clockwise until
tight.
D
D
A
C
D
A
C
