2
HOW TO INSTALL THE SECURITY LIGHT
1.
Mount the crossbar plate to the junc:on
box with the supplied screws.
2.
Place the gasket on the back of the fixture.
The gasket should create a secure seal
against the moun:ng surface.
WIRING INSTRUCTIONS
The SC1-Series Security Light operates at 120V, 50 or 60Hz.
1.
Connect the black fixture lead to the (+) LINE supply lead.
2.
Connect the white fixture lead to the (-) COMMON supply
lead.
3.
Connect the bare copper GROUND wire from fixture to
supply ground.
2
1
3
4
TO ADJUST SETTINGS
Adjustment seengs on the Security Light unit allow you to adjust TIME (how long to stay on
afer mo:on is detected), SENSITIVITY (distance to detect mo:on) and LUX (ambient light level
required before the fixture shall operate).
TIME:
Adjust from 10 seconds
(-)
/ 4 minutes
(half)
/ 8 minutes
(+)
SENS:
Adjust detec:on distance from 0 feet
(-)
/ 32 feet
(half)
/ 65 feet
(+)
LUX:
Adjust ambient light from no light
(-)
/ dusk
(half)
/ full daylight
(+)
3.
Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wires to the white
fixture wire and secure with the supplied wire
nuts. Tuck all wires carefully into the j-box.
4.
Posi:on the fixture over the crossbar and secure
the supplied long screw and rubber cover.
