background image

USE AND CARE

• Always operate, inspect and maintain tool in accordance with all regulations that may apply to 

handheld, hand operated pneumatic tools

• Use a clean lubricated air supply that will give a measured air pressure at the tool of 6.2 bar (90 

psig) when the tool is running with the lever fully depressed. Tool will operate at less than maximum 

pressure - performance will be reduced.

Beginning of each use:

• Install desired impact wrench accessory

• Lubricate tool by putting 2 to 3 drops of suitable pneumatic motor lubricating oil into the hose end 

(inlet) of the tool.  Connect the tool to the air line and run slowly for a few seconds. Disconnect to 

safely install desired impact accessory. If tool is used frequently, oil daily or when the tool begins to 

slow or lose power.

• Adjust switch on the back of the tool to desired forward or reverse motion. If your tool has multiple 

forward speeds, higher speed numbers represent higher tool power. 

• Depress trigger to operate tool. 

MAINTENANCE

LUBRICATION

Air tools require regular lubrication throughout the life of the tool. The air motor and bearing uses 

compressed air to power the tool. Because the moisture in compressed air will rust the air motor, 

you must lubricate the motor daily. An inline oiler is recommended. 

To lubricate the air motor manually: 

• Disconnect the tool from the air supply holding it so the air inlet faces up.

• Depress the trigger and place one or two drops of air tool oil in the air inlet. 

• Connect the tool to the air source, cover the exhaust end of the tool with a tower and run for a few 

seconds

• 

Do not lubricate tools with flammable or volatile liquids

www.premiumtool.com

PTA Canada   10761 - 181 ST NW    Edmonton, AB, Canada    T5S 1N3

AIR TOOLS AND PIPE FITTING SYSTEM

PART DESCRIPTION

1

Air Tool

2

Air Hose (3/8”)

3

Oiler

4

Pressure Regulator

5B

Filter

6

Shut Off Valve

7

Lead Hose

8

Coupler Body and Connector

9

Drain Daily

10

1/2” or Larger Pipe and Fitting

11

Air Dryer

12

1” or Larger Pipe and Fitting

13

Air Compressor

14

Auto Drain

15

Drain Daily

Summary of Contents for P1038

Page 1: ... and will repair or replace at its option without charge any items returned Repairs or replacements are warranted as described for the remainder of the original warranty period Providing proof of purchase is strictly the responsibility of the customer This warranty is void if the item has been damaged by accident or unreasonable use neglect improper service or other causes not arising out of defec...

Page 2: ...s experienced work should be stopped promptly to seek medical attention Injury may result from repetitive work motion and exposure to excessive vibration Loud Noise Always wear protection for eyes and ears while operating this product Follow your employer s safety policy for PPE s and or ANSI Z87 1 or local national standards for eyewear and other personal protective equipment requirements Fire or...

Page 3: ...mbers represent higher tool power Depress trigger to operate tool MAINTENANCE LUBRICATION Air tools require regular lubrication throughout the life of the tool The air motor and bearing uses compressed air to power the tool Because the moisture in compressed air will rust the air motor you must lubricate the motor daily An inline oiler is recommended To lubricate the air motor manually Disconnect ...

Page 4: ...0 438 6576 Facsimilie 780 436 4103 e mail pta premiumtool com FOR OTHER PRODUCT CATALOGUES ASSISTANCE OR A DISTRIBUTOR IN YOUR AREA PLEASE CALL 1 800 661 6576 Find us online at www premiumtool com Part Number Serial Number Date of Purchase P1038 PRODUCT INFORMATION IMPACT WRENCH PARTS SCHEMATIC ...

Reviews: