Premium PWA1210G, User Manual

Cool Mode

Use the 

Cool

mode at 

Low, Med, High 

or

Auto Fan

Speed

for cooling. Use the 

Temperature Increase 

▲

/

Decrease 

▼

pads to set the desired temperature

between 64°F and 86°F in 1°F increments.

An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on 
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.

NOTE:

If the air conditioner is off and is then turned on 

while set to a 

Cool

setting or if turned from a fan setting 

to a 

Cool

setting, it may take approximately 3 minutes 

for the compressor to start and cooling to begin.

Cooling Descriptions

For Normal Cooling—

Select the 

Cool

mode and 

High

or 

Med

fan with a middle set temperature.

For Maximum Cooling—

Select the 

Cool

mode 

and 

High

fan with a lower set temperature.

For Quieter & Nighttime Cooling—

Select the 

Cool

mode and 

Low

fan with a middle set

temperature.

Fan Only Mode

Use the 

Fan Only 

Mode at 

Low, Med 

or 

High 

fan

speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a 

Set

temperature cannot be

entered. The room temperature will appear 
in the display.

NOTE:

Auto Fan Speed cannot be used when in the 

Fan Only

Mode.

Energy Saver Mode

The fan will cycle on and off with the compressor. 

This results in wider variations of room temperature

and humidity. Normally used when the room is
unoccupied. 

NOTE:

The fan may continue to run for a short

 time after the compressor cycles off.

In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. If the 

Delay 1–24hr

feature was set, it will countdown according to the 
memorized time. You may need to set a new time if  
desired.

Power Outage Recovery Feature

Set to 

Auto

fan speed for the fan speed to

automatically set to the speed needed to provide
optimum comfort settings with the set temperature.   

If the room needs more cooling, the fan speed 
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease. 

NOTE:

Auto Fan Speed cannot be used when in the 

Fan Only

Mode.

Auto Fan Speed

4