Mounting the Headpointer on the Headset
Illustration 1 opposite page 1 shows a Liberator headpointer mounted on the headset.
The DeltaTalker, AlphaTalker, AlphaTalker II, Light Talker, IntroTalker headpointer mounts exactly the
same way, except the long, thin, round end of the headpointer points at the keyboard of your
communication device.
The top picture on the facing page shows the unassembled headset mounting pieces. You can see the
headset, a bracket, a clamp, a center mounting plate and mounting screw and a small cable-holder with a
screw and nut.
Side Mount
Find the bracket.
The bracket has a screw at the side and at the top. The side screw attaches to the side of the headset and
the top screw attaches to the clamp.
Attach the Bracket
Attach the bracket to the earpiece on either side of the headset. Place the shaft of the screw that is on the
bottom side of the bracket into the hole that is designed for it on the earpiece (see illustration on facing
page). Turn the screw until it is tight against the bracket. Later, you can loosen the screw a few turns if
you want to rotate the bracket.
Attach the Clamp
There is a separate clamp that attaches to the top of the bracket. The clamp has a small hole in the top
where the screw in the top of the bracket fits. The clamp holds the headpointer. Place the hole in the
clamp over the top screw and tighten the screw. See the illustration on the facing page. Once the clamp
is attached to the screw, you can loosen the screw a few turns to rotate the clamp (and headpointer), if
necessary.
