Step 6 (Install the body assembly with cart
assembly)
a)
Put the body assembly (G) onto the cart
assembly.
b)
Align the holes on the right side of body
assembly (G) with the holes on the cart
right panel (C).
c)
Insert one M6 x 15 bolt (AA), one M6
lock washer (DD) and one M6 flat washer
(CC) into each pre-drilled holes and
tighten the bolts by hand.
d)
Repeat the procedure with the left side of
body assembly (G) and cart left panel (B).
e)
Go back and tighten all the bolts using
the screwdriver provided
Step 7 (Side shelf assembly)
a)
Loosen the five pre-installed bolts on
right side of body assembly and allow
1/4 bolt’s length extend out of body
assembly.
b)
Align the large hole on right side shelf
(I) with the extended bolt from the
body assembly. Push the right side
shelf down until locked into place and
insert one M4 bolt (AA) into the pre-
drilled hole.
c)
Tighten the bolts by hand.
d)
Repeat the same procedure with the
left side shelf (H) and body assembly.
e)
Go back and tighten all the bolt using
the screwdriver provided
19
Summary of Contents for NG 903455
Page 40: ...N O TES A N D O B SERVAT IO N S 40...
Page 41: ......
