Page 15 of 19
General errors
F12
Configuration
There is a fault in the configuration.
F13
Base value
The basic value is incorrect.
F14
Current
The current has dropped.
F15
1st boot
The PsaControl boots for the first time.
F16
Button displ.
A button has been pressed during boot.
F17
PsaCtrl N/A
The PsaControl controller was not found.
F18
SW version
The softwareversions do not correspond.
F19
Taskfifo
The taskfifo is full.
Special errors
F20
External alarm
There is an alarm on the alarm input.
5.1.4
Resetting alarms
All alarms can be reset by pressing the red reset button once. The alarms that are no longer applicable will disappear. The alarms
which are still active will return which causes the red button to remain lit.
If the compressed air pressure is OK and an alarm remains, one of the other alarms related to the Multi-F's hardware is active. A
service technician must read out the controller. Please contact PRESSCON. Also in case of technical failure, questions or other
issues you can contact PRESSCON at any time.
5.2
N-Gen control
5.2.1
Faults and alarms
The error levels are divided into four categories. Of these four categories, the lowest two are warnings and the highest two are
alarms. Warnings report the error, but do not affect the operation of the N-Gen Control. When an alarm occurs the N-Gen Control
will stop functioning. It will then no longer be used in the system. Per type of error message (Warning and Alarm) there is a
difference between local and system error messages. If the error message is local, it is only handled locally. If the error message is
for the system, the system will respond to this error message.
Level
Name
Description
Range
None
None
No error level
N-Gen Control
Level 1
Warning local
Warning for this N-Gen control only
N-Gen Control
Level 2
System warning
Warning for the whole system
System
Level 3
Local alarm
Alarm for this N-Gen control only
N-Gen Control
Level 4
Alarm system
Alarm for the whole system
System
Summary of Contents for N-Gen
Page 2: ...Page 2 of 19...
