9
5.2
Some typical cleaning tasks
5.2.1
Agriculture
Task
Accessories
Method
Stables
Pig Pens, Sties
Chemical Foam
Injectors
1.
Soaking
– apply foam to all surfaces (bottom to top)
and wait for approx. 30 minutes.
2.
Remove the dirt from surfaces with the high
pressure lance or chosen accessory. Again, clean
from bottom to top on vertical surfaces.
3.
To flush away large quantities of dirt, change to low
pressure mode and use the higher flow to push
away the dirt.
4.
Use recommended disinfectant products and
methods to ensure hygiene. Apply disinfectant
once the surfaces are perfectly clean.
Cleaning of
walls, floors and
equipment
Foam Lance
Floor Cleaner
Disinfectant
Detergents
Disinfectant
Machinery
Detergent injection
1.
Apply detergent to vehicle or equipment surfaces in
order to soften up dirt and grime. Apply from bottom
to top.
2.
Proceed with cleaning using the high pressure
lance. Clean again from bottom to top. Use
accessories to clean in diffi cult to reach places.
3.
Clean fragile areas such as motors, rubber at lower
pressure levels to avoid damage.
Tractors
lances and
Ploughs etc.
underchassis washers
b
rushes
5.2.2
Vehicle
Task
Accessories
Method
Vehicle bodywork
Standard lance
Detergent injection
under chassis
washers brushes
Detergents
1.
Apply detergent to vehicle or equipment surfaces in
order to soften up dirt and grime. Apply from bottom to
top. In cases of particularly dirty vehicles, pre-spray
with
a recommended dealer product
in order to
remove traces of insects etc, then rinse at low
pressure and apply normal car cleaning detergent.
Let detergents settle for 5 minutes before cleaning off.
Metallic surfaces can be cleaned using
a
recommended dealer product
.
2.
Proceed with cleaning using the high pressure lance.
Clean again from bottom to top. Use accessories to
clean in difficult to reach places. Use brushes in order
to add a mechanical cleaning effect. Short lances can
help for cleaning of motors and wheel arches.
U
ndercarriage washers can be valuable for the
cleaning of car underchassis and wheel arches.
3.
Clean fragile areas such as motors, rubber at lower
pressure levels to avoid damage.
4.
Apply a liquid wax using the pressure washer in order
to protect the bodywork from pollution.
