Testing / setting your
RALLYE
MASTER
SPORT:
1.
Set the ON/OFF switch to “ON“.
2.
Set the two coding switches to “100“.
3.
Slowly move the vehicle for several metres. (The counters must
start to run!)
4.
Set the counters to “0“.
5.
Press the pushbutton “9” (reset) once for at least 3 seconds (until
the signal sound can be heard) in order to delete any pulses
stored, if any, from the electronics.
6.
Drive a specified measuring distance (at best 1,000 m,
comparison with navigation device or reference distance of the
rally organiser) with a constant speed of max. 50 km/h.
7.
Note down the value shown on the counter after the measuring
distance has been completed and enter this value in the coding
switch “4“.
Thus, your RALLYE
MASTER
SPORT is calibrated on both counters.
If your RALLYE
MASTER
SPORT is used in several vehicles, repeat this
procedure for each vehicle and note down the respectively set value.
If a measuring distance is available at an event, you can exactly calibrate
your RALLYE
MASTER
SPORT to the reference measuring device of the
rally organiser by applying this procedure!
Average monitoring using the
RALLYE
MASTER
SPORT
and an
average computer:
The RALLYE
MASTER
SPORT can also be used to monitor the average.
Using an optionally available cable set, an average computer can be
connected. The automatic synchronisation of data can thus be carried
out precisely. The average computer must be equipped with 10 m signal
processing and an operating voltage of 12 V.
Please note:
The connected average computer interacts with counter 3 (counter in the
centre); here, calibration in steps of 10 m each must be performed (as
described above).
If you use the “Back“ function with the sound signal, the 100 m signal
sounds despite the standing devices!
