background image

4

128-8612

4 of 8

ORDER  FORM  FOR  91P

Attention: Transmitter Ordering Department
Important:

  To help us expedite your order, please print all of the information legibly and

mail this form and your payment according to the instructions below.
Note: Transmitter model number found on back of case.

1) Transmitter Model Number_____________________

2) Name: _______________________________________

3) Address: ______________________________________

4) City: ________________ State: _____ Zip Code: ________

5) Telephone Number: (_____) _______________
6) Total Number Of Transmitters Required:

Cost Per Transmitter is:

$65.00

Multiply By Number Of Transmitters            X ______

7) Enter Total Amount Enclosed _________________

(New York State Residents must include the appropriate sales tax)

8) Method of Payment:

 

 

Mastercard 

 Visa 

 Check or Money Order (do not send cash)

Make Checks Payable To Audiovox Corporation

Credit Card Number: _________________________________

Credit Card Expiration Date: ____ / _____ / _____

9) Mail this form along with your payment to:

Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y., 11788

Attn.: TRANSMITTER DEPARTMENT

BATTERY REPLACEMENT

The transmitter incorporates a small LED visible through the case which is used to indicate battery
condition.  You will notice a decrease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to 12 months, depending upon how
frequently the transmitter is used.
To replace the battery in the 91P Transmitter

1) Carefully Separate apart the case using the edge of a coin as

shown.

2)  Remove the rear cover to access the discharged battery

paying attention to the proper polarity orientation.

3) Carefully remove and properly dispose of the discharged

battery.

4) Insert the new battery, than carefully snap closed the

transmitter case.

5) If you accidently dislodge the circuit board from the transmitter housing, be certain that the rubber

membrane is seated properly, and the buttons are properly exposed from the front view of the case,
then insert the circuit board, and return to step #4.

91P Uses 2 x CR2016 Lithium Battery

CAUTION: 

CARBON MONOXIDE GAS CAN CAUSE SERIOUS INJURY AND EVEN DEATH

It is the sole responsibility of the user to operate the vehicle this system is installed in a safe manner.
This device must not be used in an enclosed space like a garage, attached or detached, car port, or any
partially enclosed areas.  Also this device must be placed in the service mode when dropping the vehicle
off for service to prevent injury to the service technician.

©

  2009 Audiovox Electronic Corporation 150 Marcus Blvd, Hauppauge NY 11788

128-8612

Credit card purchasers can order additional or replacement
transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and
follow the instructions from the operator interface.

Reviews: