128-9306
14 of 32
14
30
87a
85
86
87
Black
Black/White
Existing Low Current
Start Solenoid Wire
From Ignition Switch
Start Terminal
To Starter Motor
X
Cut
To Orange Wire
Of Alarm/Remote Start
To + 12 Volt Ignition / Start
22 Orange Wire:
300mA (-) Ground When Armed Output
This wire provides a 300 mA ground output when the alarm circuit is armed to control the starter inhibit
relay. Connect the Orange wire to terminal #86 (orange wire) of the relay provided. Connect terminal
#85 (red wire) of the relay to an ignition wire in the vehicle that is +12 volts when the ignition switch is
turned to the on and start positions and off when the key is off. Locate and cut the low current start
solenoid wire found at the vehicles ignition switch harness. This wire will have + 12 volts when the ig-
nition key is moved to the start (crank) position and will have 0 volts in all other key positions. Connect
one side of the cut wire to terminal #87a ( Black wire) of the relay. Connect the other side of the cut
wire to terminal #30 (White/Black wire) of the relay. See below for detail of wiring, also see Yellow Start
wire detail for connection to vehicle considerations.
Summary of Contents for APS-787E
Page 30: ...128 9306 30 of 32 30 NOTES ...
Page 31: ...128 9306 31 of 32 31 NOTES ...