128-9306
15 of 32
15
4 Pin Additional Harness:
Parking Light Flasher I/O Siren & Ground
Part # 1284301
1 Black:
Chassis Ground
Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis.
Be certain to remove any paint or grease and secure this wire with a self tapping screw and ring terminal.
2 White w/ Red trace Wire:
Parking Light Relay Input Wire
This wire is the common contact of the on board parking light flasher relay. If the vehicle you are working
on has +12 volt switched parking lights, connect this wire to a fused + 12 volt source. (Max. 15 Amps)
NOTE:
If the vehicle's parking lights are ground switched, connect this wire to chassis ground.
3 White w/ Black trace Wire:
(+)
Siren Output
This is the positive siren feed wire. Route this wire through a grommet in the firewall to the siren location.
Connect the White w/ Black Trace wire to the Red wire of the Siren. Secure the Black wire of the Siren
to a known chassis ground or solid clean metal surface.
4 White Wire:
Parking Light Relay Output
This wire is the normally open contact of the on board parking light flash relay. Connect this wire to the
vehicle's parking light feed wire. This is the wire that gets switched on, either (+) or (-), when the vehicle's
parking light switch is activated.
Typical Vehicle Parking Lights
From Vehicle
Park Light Switch
White From
Remote Start Module
To + 12 Volts
(If Gnd. Switch See Note)
White/Red Wire From
Remote Start Module
15A
Summary of Contents for APS-787E
Page 30: ...128 9306 30 of 32 30 NOTES ...
Page 31: ...128 9306 31 of 32 31 NOTES ...